You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Quoted from In99flames:found an open resistor at R9.
From manual it looks that R9 is used for sol#15 "low PF G.I. relay" . Think that the drive transistor Q14 was shorted and kept the relay powered ON and cooked the resistor R9.
But I'm not sure because manual and interpretation can be wrong.
To be sure, check which transitor is connected to R9.
Quoted from In99flames:what about the large 30000uf cap in the backbox
Quoted from In99flames:Sometimes I cannot get it to boot unless i turn it on or off 3 or 4 times.
More likely it were the smaller caps C7 and C8 on the power supply going out of spec.
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/earthshaker-interconnect-board?tu=zaza and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.