Quoted from pinballdork:Hi, I'm helping my brother over the phone repair a Target Alpha that had something happen to the DX relay. I suggested he remove the switches one block at a time straighten the switches and put back into the switch actuator. But he is having difficulty ensuring they blades are in the correct position and he is not sure if there are any tricks in reassembly. Any one have clear pics of the DX relay from both sides, and some tips in reassembly? Thanks! Glenn
Looks like the two switches on the end should have their long blade one slot closer in to the body of the relay. As should the next one in with green and red.
A picture from the other side would help check the ones we can't see.
The manual or schematic will list the number of make, break, and make/break switches on the relay.
