Looking good!

On the decals, if you have access to the printer, it may be easier to just run them through twice to get the right darkness for the letters. I think I did screw one up with poor alignment, but the printer did get the second aligned without a ghost image on the letters. That might be easier than aligning multiple decals by hand. You can always try first with a regular piece of paper to see how consistent the printer feeds.

I think most were sized to what I saw on my playfield. Some I might have fattened up since I had a pretty poorly registered printing on my playfield. A little extra never hurt anybody...

Same reason the 100 and 1000 near the spinner have different "1's"...as well as the 1000's near the outlanes. There are so many font errors on Firepower it should become a drinking game. As I recall though, the 5 for the triangle on the decal for the orange arrow did match the original 5, albeit different than the other "5's"

My advice: Don't zoom in!

Now get the gray paint out for the mortar between those bricks! In for a penny, in for a pound.

I have a feeling I know what the next image will be ...

It would be the snazziest Firepower bottom around!

I think Vid had something in his playfield guide about trying to drip clear in with a syringe to fill the gap and fix the ghosting. Other's may have tried super glue?

If you can't find one shoot me a PM with your address I have this one which I believe would work... It is axial right?

15936495890047159883810512893621 (resized).jpg