Did you check the 2 amp slo-blo fuse for the Target Bank Reset Coil?
I think it's under the playfield.
You're currently viewing posts by Pinsider pdman.
Click here to go back to viewing the entire thread.
Did you check the 2 amp slo-blo fuse for the Target Bank Reset Coil?
I think it's under the playfield.
Do these measures with the power off.
Disconnect connector A3J4. Check continuity from A3J4-2 to the orange/black wire on the target reset coil. Should get ~0 Ohms. Use the ohms scale set to the lowest range to measure this.
Next measure from A6J5-9 (or from the 24VDC Bridge Rectifier + output) to the green/yellow wire on the target reset coil. Again ohms should be ~ 0 ohms.
You're currently viewing posts by Pinsider pdman.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/drop-target-problem-with-my-system-1-pin?tu=pdman and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.