my new bsd board just came in and it instantly blew the c11 capacitor on the power driver board.just spent over a hour on the phone with my board repair guy going over every wire and connection and it still blew the c11 capacitor on the new board.im sending the boards back obviously but I'm definitely dumbfounded on where to go now.my guy is thinking may be the mist motor did it but i dunno.figured I would ask the community.it only blew when i hooked up ribbon cable bc i did the trick with plugging 1 at a time and turning on and off.any advice is greatly appreciated

20190105_120330 (resized).jpg

ok will definitely try it.will be sending both of my driver boards back for repair with flipptronics board as well so my board technician can try them out on his test bench.thank you

j124 was plugged in 124 as well so I'm thinking flipptronics board is the culprit from your response

I did and no my left gate wasn't working on mist and castle lock wasn't working