You're currently viewing posts by Pinsider adams_arcade.
Click here to go back to viewing the entire thread.
Yes this looks right but the assembly doesn't exist. I will need help with each part identification of this assembly. Also this seems to grab (scratch) the side of cab causing a groove. It does seem to be an alignment issue as this machine just had a playfield swap but would like some suggestions.
Thanks. I am also noticing my playfield seem to lean to the right. This is wired because this is a different playfield but using same brackets. Is there a procedure to level it so the playfield stays centered while lifting?
According to Marcos site...
Pivot nut 7/8 inch #02-4329-1
I have the bolt, is the nut anything special? Do I need a washer?
I'm hoping one of the bushing are wrong or worn.
The cab was just restored so the hole is correct.
You're currently viewing posts by Pinsider adams_arcade.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/dr-who-playfield-part-identification?tu=adams_arcade and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.