A pinball leg mounts with two holes with two bolts, not four holes with two bolts.....

IMG_0722 (resized).PNG

Every hole has a top and a bottom, just because it goes all the way through doesn't make it two holes.

Drill four 1" holes, evenly spaced, through a 2x4, what does that mean to you? Seems pretty clear to me, the some Smart ass drills two holes and says it's four holes (because he counts both sides?). Ask the same guy to drill one hole through the 2x4, does he get "lost" say that's not possible, holes come in pairs?

Hey Joe, drill 8 holes in this pinball cabinet for legs, again pretty simple, the bolt passes through the hole, like water through a straw. But joe only drills 4.... and gets fired

If you can put your finger in one side of the hole and the same finger pops out the other side it's the same hole....

I would like a straw with ONE HOLE please, maybe someone (who thinks a straw has two) could show me what that looks like.....do you cut it in half and then it has one hole?

So at what point does it go from being a hole to not being a hole? Is it length! Or process? If I cut Bar Stock into a 4" length and physically drill the hole (like a straw) is it then a hole? If I drill one hole through the bars Stock, when does it become two, even though I drilled just once.

IMG_0726 (resized).JPG
IMG_0728 (resized).JPG
IMG_0727 (resized).JPG

A single component is different than a system, and a living person is certainly not the same as drilling a single hole through a metal bar, wood or plastic.

To me this analogy is comparing to a "sewer system" waste water goes to the sewer plant for treatment and back to your faucet, certainly not the same hole. If you want to tie into the sewer system you have to drill a hole into a pipe to tap in. The system is full of pipes, holes, turns, etc. it's a system, not a single component like a washer, or a tube.