Hello Who'ers! I recently joined the club and purchased a very nice Doctor Who from @Kronlar. I have appreciated reading through this thread and the history has been so helpful. My purchase timing lined up with some 3D design and printing I have been tinkering with at the local county library. I went ahead and designed & printed some dalek pinball posts inspired by others I saw in this thread. Here's a link to the 3D design if anyone wants to print some.

https://www.thingiverse.com/thing:3275089

IMG_5344 (resized).JPG

IMG_5426 (resized).JPG

IMG_5429 (resized).jpg

The translite on my machine always bled light through a little bit due to a spill before I bought it. I read a bunch of threads and decided I was going to attempt to fix it by adding some opaque white. Long story short when dabbing it with a wet paper towel it got really bad. Anyone know of where I could source a NOS or used one?

drwho (resized).jpg

Did you use my design? Nice looking prints!

https://www.thingiverse.com/thing:3275089