Hello
just made another small batch of my mod for Dr WHO pinball

Legend has it that the first first 100 Doctor WHO games produced had a moving Dalek topper, now you can get yours moving!
So my mod will pulsate LEDs within the head simulating a breathing Dalek, however when triggered by the original flasher lamp the Dalek sweeps left to right then reverts to its home position. Whilst moving the Dalek lights will flash just as the original flasher lamp would have before reverting back to the intial breathing mode.
NOT A COMPLETE PLUG AND PLAY MOD KIT
This kit contains the control PCB, LEDs/resistors, Connectors & fixings, and evaluation servo motor
You will need to make some simple plastic brackets and cabling
You could initially install the visual LEDs and later add the movement side.

you tube video here

install instructions and purchase here https://www.pinballtoys.co.uk/?page_id=835

cheers Bob

20190111_171940 (resized).jpg

i currently have only 27 kits left from my original run of 120

doubt i will be doing such a big production run of these again

If your tempted see https://www.pinballtoys.co.uk/?page_id=835 for install/guidance instructions

Regards Bob
PinballToys.co.uk

20201215_093050 (resized).jpg