I am working on a Rottendog DMD089-1 DMD driver for a friend. It runs but has graphics issues as shown in the pictures below in a Dr Who machine. The same issues occurred in a Dracula and Adams family and follow this board. There was a question if the RAM was correct on the board but I doubt that is the issue. From what I traced out it looks like it uses the same 6264 chip as the WPC board. I've tried swapping the RAM with known good tested chips and still get the same mixed up display. Looks like it is some sort of addressing issue either writing the image to the RAM or when pulling it out. Has anyone experienced a similar problem with either a Rottendog or genuine WPC DMD driver?
20201109_182251 (resized).jpg20201109_182258 (resized).jpg