Just got my boards in that have been in a box for a while refurbished by Chris Hibler here. So here's the issue....

I have a couple targets underneath, one in the middle that's disconnected and one near one of the subways that's also disconnected (as shown). (Pics to follow) I believe I have the boards connected properly. Receiving Slam Tilt Stuck error message. None of the lights in the backbox or playfield come on at all but it acts like everythings fine on the DMD other than when the coin door is open.

Not sure where to start really as this wasn't an issue before sending the boards off to Chris. Just an issue with the elevator not getting full juice as it seems.

Thanks for any help you can give.

19075321_10154718962281446_774586035_n (resized).jpg

19113118_10154718962606446_354787712_n (resized).jpg

19113247_10154718962476446_671849239_n (resized).jpg

19141655_10154718962481446_470992746_n (resized).jpg

19141869_10154718962816446_141970366_n (resized).jpg

Just a reminder, I had to reconnect everything to the boards and properly labelled everything as best I could but doesnt mean I could have possibly not connected something properly too. Also the switch connections I had had issues with I reconnected and now work when tested. (And there was some rejoicing...)

Lloyd, I pulled all the switch connections as suggested and got "Check Fuses 114 and 115". Just tested all the fuses, all work.

So need to send the CPU board back again? Does that explain why nothing is lighting up as well?

Yeah that's what it was from the small ribbon connecting the power board to the CPU board. Game lights up now. (Thanks!!!) Crane and Elevator tests still do not work, still receiving the Slam Tilt stuck message right off the bat after the Testing screen. Will take pictures and post them shortly.

The crane would, the elevator would struggle to get to the top. Nothing tests when it's fired up, it lights up and all however now due to that ribbon cable between power and CPU.

Here are the photos as well.

https://photos.google.com/share/AF1QipNHdNQTsNpe8rs7BYFPiXJ4i-LTDAi-ulqMfCSEVg-J4rLCey-iG-rNvoQ_u_9d9w?key=V3VPQWExUV91NFNMX21hOXg5dzg1U2VfeHh0X0Jn

All fuses check out, just checked them all.

Yes, Lloyd had me unplug them temporarily on the MPU board and it gives the Check Fuses 114 and 115, which check out when tested. Plug them back in and get the Slam Tilt message.

Meaning usually when you start the game, the crane and elevator test. This doesn't happen, it sounds for a brief half a second like they want to and then get the slam tilt stuck message.

When I unplug all the switch connections on the MPU, I get that message.

U20 on the MPU is directly on the board. Chatting with Chris via gmail right now.

Can't get into the switch test either. Goes directly to the slam tilt message. LED3 on the power board has a low intermittent flicker as well (found out this isnt a big deal).