Quoted from Yelobird:Time to re-assemble the whole mess! Do note I added a small washer to the back post and recommend the Same on any small diameter post as I believe there is simple to much applied pressure for that small a footprint. Just make sure to put the more radiused side of the washer down not the sharp edge side. Very Important!! Screw the posts in with your fingers NOT a big wrench! When you tighten the top plastic down with the nylon nuts it will be More than tight enough. Less is More! As you can kind of see in the final photos the end result is rather spotless. After a few weeks of observation I have not seen Any deflection or change. Possibly (assumed) the iron is actually heat setting the clear in that area which hopefully minimizes the chance of this crap coming back!
I do hope this helps those that are plagued but this unfortunate event. It truly sucks and is no doubt a blow to this rather Expensive hobby. Let me know if you have questions. I will report back if I see Any change to this repair. On to the Next Flippen game!!![quoted image][quoted image][quoted image]
Great job. Do u think a heat would a heat gun would work?