OP

Quoted from djb_rh:

Note that yes, I am going a tad taller than the TinyArcade, too. And even so, it'll be about a quarter inch shorter than the usbjig cabinet, but I'll just mount it a tad higher and you won't notice from the angle in the Tron LE that you look down at. I'm also not planning a back door since it's actually pretty hard to get where you could see in the back on the pinball, too.
These appear to be JST-SH connectors for the battery, so I've ordered some of those and plan to use that for power (and no battery) in the pin. Looks like it will just start up and do the right thing when power is applied if the power switch is on. So I'll make an adapter cable to go from that to the Stern aux power connection.
--Donnie

OP

Quoted from djb_rh:

Finally took a little time to do some more work on this. Got a couple more of the pieces done. Doesn't look like I've added much, but to get this far took doing a test cut of the pieces and then some tweaks to get them right. I just need to do the ears on the cabinet top and then do a coin door piece and a bottom and it should be done.
--Donnie
[quoted image]