Quoted from Tom65:Is this plug on the right position?
No
It should be on J2.
The Connector on J15 received 12V with reversed polarity. Don't know if it blew something.
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Quoted from Tom65:Is this plug on the right position?
No
It should be on J2.
The Connector on J15 received 12V with reversed polarity. Don't know if it blew something.
Quoted from DumbAss:If I read the schematic it looks like it's ok.
J2 is 180º rotated relative to J15 and J16.
Seen by the silkscreen, +12V should be left and GND on the right side. This means that the connector on J16 (in the picture post#12) is the one that comes from the powerboard and carries the power and must go to J2 !
And the connector on J15 (correct gry-yel on left side) is now receiving 12V with reversed polarity.
If something on this powerline has a pcb with polarity sensitive electronics ( steppermotor driver in backbox ?) it could have caused to blow the fuse on the powersupplyboard for the 12V,......this is also where the +5V is derived from.
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/diner-display-is-dark-after-restore-?tu=zaza and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.