I know it's a long shot, but anyone want to sell me used/new/I cracked sling plastics? Def don't need a complete set, but maybe you replaced yours and have spares? Thanks!

Diner is such a mega fast game. Love it.

My two cents on the cup shot: I almost always see the max amount scored and then a few extra loops. No new ramps or cup, just nice polish. Make sure the switch doesn't resist the ball much. Should get 3.5M no problem.

I disagree that the switch is supposed to register only half the time -- I swear it chimes for each pass...

I have a sample and the scratch is there. Could no scratch=shooter lane switch bad?

There are four screws on the register face that allow you to access the board with 555s mounted in it underneath. It's easy to get at and you can swap lamps topside. Make sure you have some slack from the wire harness and you're good.

I'm blowing the saucers/ramp down coil fuse and could use help diagnosing why.

It will play seemingly many games before this happens, and replacing the fuse temporarily fixes the issue.

It happens either on startup and I don't notice it, or it happens when the ball hits the first saucer lock on the skill shot past the jukebox. Either way, it sticks there and doesn't kick out.

Not sure what can cause intermittent fuse blowing in a coil, so your testing tips are most welcome. Thanks!

Thanks much -- I'll explore some options with this advice. Now that you mention it, a flasher on the same circuit (Hadji) was sticking on, and I replaced it with an LED a while back. Perhaps another is doing the same... And maybe this can ultimately be traced to the flasher transistor.

It was the flasher transistor. A small metal flake had fallen onto the transistor legs and shorted it on. I noticed after pulling the board and flicked it off. 100% fixed. *Eye-roll* Pinball amiright?

My Diner has this same bracket. Really mysterious why... Ball hang ups?