Fixing up a Diner and the coin door has taken a beating. The game will be setup for free play, but the coin door needs to be straightened out.

The switch in the upper left, is this supposed to be a slam switch? It looks like somebody cut part of it off.

If possible can someone share a photo of what the mech side of the coin door is supposed to look like?

05AE3419-A86E-481C-BD0D-94CCF9E65DDB (resized).jpeg

As I was de-populating the playfield of the Diner I'm working on, this metal piece was sitting on the playfield hiding under the coffee cup. Can someone point out to me where it goes? I'm not familiar with the game, just doing a playfield swap for a friend.

I can see the piece has a ball track on it, I just could not figure out where it goes.

I also found a small, 1" wire form in the bottom of the cabinet. I looked at all the places on the playfield where this wire form could have come, but I don't see a spot for a missing wire form anywhere.

Thanks again for all the help,

Alberto

_102_unknown_piece (resized).jpg

_103_unknown_piece (resized).jpg

What is the part number for the Diner flipper button? I don't see it in the Manual. The Diner I'm shopping out has two different buttons and I would like to make them match. I think PBR has the correct button, WLL-A16883-4, but I wanted to double-check.

The Diner I’m working on bringing back is missing some hardware. Can someone please post a photo of the intersection between the left side upper ramp and the right side ramp? Then I can see what hardware is used.

All those screws were missing and the ramps were broken.

Alberto