Can anyone tell me what type/size of screws are supposed to hold the 2 ramps together. (where the metal part connect both ramps)

Also, what is the type/size used to connect the ramp and the cup?

I'm under the impression that the one installed on my machine are too big or something, as they pop out instead of being flat.

Yeah I would like to know the exact # if possible. The one used to replace old screws look like 1mm too large or something.

I might remove the ones on the cup then, cause they pop out like 4mm in the air. Don't think it's really good for the ball, or the cup scoring.

That's cool, maybe it's time to test those UV LEDs...

On another topic, I'm currently changing rubbers on my Diner, and I want to remove the top left ramp. I noticed that there is a switch wire is going directly through the ramp plastic and is not held by a Tierap like the other ramp.

Is there a way to remove it other than unwelding the switch and weld it back after?

Nice, I'll have a look at all these pics. I'm doing the same to remember how to put it all back together.

So you put back the register before installing the ramps?

BTW: Tu a pris ou tes cards, sont vraiment cool!?

I've changed most of the rubbers and I was wondering; is there an error in the manual? They list 3x (C 1 1/4 rubbers) and only 1x (F 3 1/2 rubbers). I'm stuck with a "C" that I don't know what to do with.

Also, when you want to change LEDs in the jukebox and the EAT. Can you do it without removing the back box? I was able to acces the LED with the playfield half lifted. But was wondering if it was the way to go, since you don't really see what you do. It would be kind of bad if you need to remove everything to change one bulb...

BTW I found the rule card on the net too. It's the last Diner file on that page.

http://www.pinballrebel.com/game/pins/instruction/index.htm

Strangely, it's the free play card I can't find. I remember seing it somewhere before... Do you have any leads?

Ah! Just found it, it's in the images of this topic........