You're currently viewing posts by Pinsider 1iblind.
Click here to go back to viewing the entire thread.
The A/C select relay clicks on and off 8 times on power up and then it stays activated. Q8 (TIP122) on the CPU tested fine but I replaced it anyway with the more robust TIP102. Still having the same problem with the relay staying activated. The relay is also new. When I got the game the relay contacts were melted together causing solenoids 1-8 to not work.
Got the logic probe and tested pin 13. It was reading high, low, and pulsing. I left the game on a few minutes and went back to testing. This time the pins around 13 were reading low but 13 was reading high. So I replaced U38 but still had the solenoid clicking on and off and eventually staying on. Logic probe read high, low, and pulse. Waited a few minutes with no change in reading. The relay works fine in test when switching from A to C but still clicks about 8 times on power up.
Quoted from wayout440:Wow. That sounds strange. If the A/C switching works consistently in test mode, then that pretty much confirms everything from the PIA to the coil is ok. Higher level logic problem, I think. Maybe game ROMs or RAM.
Tried new ROMs and still no go. How would I go about testing the RAM?
Quoted from wayout440:You can buy or borrow a RAM tester, or build one from a kit https://pinside.com/pinball/forum/topic/williams-system-11-u25-part-no-needed
Or, just replace it with NVRAM and never worry about changing batteries again https://www.pinballlife.com/anypin-dmd-nvram-battery-eliminator.html
Board doesn't have any battery corrosion. Put in NVRAM today and still have the same problem.
You're currently viewing posts by Pinsider 1iblind.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/diner-a-c-select-relay-issues?tu=1iblind and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Albuquerque, NM