I was having the same problem a lot of others were having with the ball bouncing out of the left ramp exit. I decided to make a small wire form to keep it from bouncing out. It was easy to make, and it does a great job!

I used a push rod (size .08") from some old rc parts I had laying around. Any thin rigid steel rod should work though.

Another nice thing is that it's less noticeable!

img_4 (resized).jpg

img_3 (resized).jpg

img_1 (resized).jpg

img_2 (resized).jpg

Yes, that's was I was thinking too, so I went ahead and just made a smaller, less noticeable one with wire. I may try and print a small piece of plastic to 'snap' on the top portion to extended it back a little, something even smaller and easier than the formed wire method.

It doesn't happen very often, but does anyone have a fix for the ball dropping into the cabinet through the Bob door?

Thanks!

Thanks, I'm not quite sure I understand, the ball doesn't get stuck, it falls into the cabinet, there is a large space that the ball can go through into cabinet instead of dropping into the habitrail, it almost looks like there should have been something there to keep it from dropping out.

Ah ok, I'll give it a try tonight!

Thank you!

Does anyone know if you can use a different ssd when the current one goes out as long as it's same size or larger capacity?

Thanks!

Thanks, it doesn't recognize the drive anymore. I took it out and tried it on another Dialed In and it gives the same error so it looks like it's dead. I just ordered another 60gb ssd, I'm hoping that booting from a full install thumb drive it will format and do a full installation.

While I'm waiting for the new ssd to be delivered, I decided to try an old non ssd 160gb laptop drive. It installed 1.60 with no problems and works, though it does take a LOT longer to boot, lol.