Is Armageddon the final wizard mode?
I see a lot of people have made it to this... is the game quite shallow? How many modes/ disasters are there?
Don't know if I should get a DI or wait and see what a GOTG is like.
You're currently viewing posts by Pinsider Pinhead1982.
Click here to go back to viewing the entire thread.
Is Armageddon the final wizard mode?
I see a lot of people have made it to this... is the game quite shallow? How many modes/ disasters are there?
Don't know if I should get a DI or wait and see what a GOTG is like.
My D.I LE arrives tomorrow!
Downloading the new 1.50 code now.
From what I've picked up from this thread:
Set magnet in Theatre to -90 and tweak until ball goes up towards right flipper
Left ramp exit- ball bounce outs- raise with a couple of small washers and put Velcro!? under the wire form I assume to slow the ball down?
I've been reading about scratches that appear where the flippers are? Any preventative measure to stop this from happening?
Hole protectors- JJP ones bit naff, so order & fit Cliff ones.
Anything else?
Thanks
Quoted from Connor:Where can I get some of these super shiny carbon balls?
+1! Put a seperate post out to find out who supplies them
Quoted from Zampinator:It's grazing the wire ramp just in front of the scoop as it ejects. It's lightly hitting the bottom side of the ramp & slowing it down & putting backspin on the ball, it's hard to detect. To verify this, take the glass off & start a game. Put your index finger on the top of the ramp in front of the scoop. Put the ball in the scoop with your other hand & let it eject. If you feel any vibration from the ball hitting the bottom side of the ramp, you need to bend the tab of the scoop down until the ball does not hit the bottom side of the ramp. I did this to mine & it fixed it.
Good luck.
Thanks.. a friend worked this out when we were playing, lowered the coil power to 15 and it’s fine, good kickout with no issue.
Thanks again
New issue.
Black bottom Drone not working,
It is intermittent.. on going onto YouTube and looking into how it comes apart, going to have to take the ramp off and go from the underneath. It looks like either motor shaft bent or wires that powers the motor are loose.
If I touch or hold the Drone motor blade the other 3 spin.. are they all chained together?
I’ve asked my distro for a new one.
Question is do JJP just send a Drone or will it have the wire harness attached so I can just run the wires? LTG any help would be appreciated
Thanks
Is there another code due for release?
Since updating to 1.50 some of the phone animations don’t work like they did in 1.13
Does anyone know when new code will come.. Running 1.52, I heard new code/bug fixes was comming last month.. not sure where from..
Also 1 LED on my phone is out.. new phone or just an LED board?
Thanks
The LED is on, but very dim compared to the others.. It is a recent thing as when I read about others phone issues months ago. I went and checked mine
Can people who have recieved manuals tell me when they bought the game.. I was one of the first UK back in Oct/Nov 17 and not heard yet of manuals being sent out
Didn’t JJP do a plastic clear piece to stop bounce outs.
Jack gave me one back in January at EAG London
Quoted from mrgregb123:Can anyone PM me a link? I requested access, no response. Much appreciated.
⬆️⬆️⬆️⬆️⬆️ Me too!
Hi All
My screen has started to flicker
Horizontal lines
Any idea of what it could be..
It kinda happened at the ball end but now you can see it during the ball on the city landscape
Thsnks
What is this Processor swap that is mentioned?
Where can I get this & how much is it please.
jrawlinson_2000 - likely you drone motors are knackered- contact Phil pinballheavenuk he can help you out.
Quoted from Noma2017:DILE meets Wonka. Thanks for the help!
[quoted image]
Nice line up..
Here’s mine! Love the way the two compliment each other.
Quoted from holminone:It’s a good question. Could be theme. But I think for them it’s just not as rewarding or satisfying. More frustrating.
Do they know the basic rules? Hit QED to charge phone, make phone scoop to start the mode?
Taking the phone scoop off was the best thing I did! Takes a lot of frustration out of the game..
Hi All- couple of things
Bought an isolator a while back fitted it, today turned game on and a consultant tick tick tick tick tick sound came from sub. Played with the isolator and it went away.. anyone else have this?
Also today- game is racking up points when I or press the flipper buttons.. 10pts.. every press from any flipper!
Is this likely vibration setting off a switch? Or something more sinister?
Yeah @daveddd14- was this, drone rubber - put it in switch test and pressed the flippers. Been playing for last hour, and the tick tick ticking is back.. cheap Amazon noise filter
OK- that’s interesting with the isolator..
Another thing, the Phone scoop- pitch is OK I think, the phone scoop kick out- reduced it a while ago and then removed the scoop protector to reduce bounce outs... anyway.. put it back up to 17 today (JJP recommendation) and the ball fires out and hits the cross over ramp. Think the scoop itself the roof could need bending down a bit, anyone else have this issue?
Hi All
So today my Theatre screen turned BLUE- all animations just on single colour..Blue..
I turned the game off, lifted the playfied and. Checked/ reseated some connections.
The screen did return to Semi normal, with different colours, but looks a little washed out..
anyone had issues like this?
Thanks
Hi All.
I have a question
Should the theatre magnet always have a current going thorough it? Playing my DI today and magnet was grabbing but not flinging the ball.
Adjusted it from 144 to -90 and it worked a couple of times. Thought magnet must be hot so left it for 5 mins and put my finger on the magnet. Still warm but not burning.
But all the other magnets became cool after I tested them a few times - drone & centre playfield.
Could a DI owner please have a look of the theatre magnet is warm just by turning the game on..
Hope this makes sense.. this maybe one for LTG
You're currently viewing posts by Pinsider Pinhead1982.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/dialed-in-owners-and-fans-club?tu=Pinhead1982 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.