Hello to all!

So I finally was able to get my hands on a DemoMan (in parts) and I'm trying to put the ramps/playfield together, I've read that there's only one way on how you should put the ramps back (their order) can someone be kind enough to point me on how to make this, I tried but I'm sure I wasn't make it correctly.

Thanks in advance!

~j

Thanks! I do have the manual, but because I got this machine disassembled, I'm looking more for a visual guide, like on which holes should I go through for the switches, which ramp goes above what, etc.

As for the measurement, sure! Is it this what you are looking for? (attached)

TIA!

~ja

DemoMan Trigger Handles (resized).jpg

So... I (finally) have my first DM, woohoo! while playing without the glass (testing switches) I noticed on how loud is the sound every time the ball gets into the "computer" (or tunnel) is there a way to muffle the sound? I know that with the glass on the sound is minimized, but also, I think that having some type of dampening material will also absorb a bit the force of the ball getting into, keeping the welding spots of the "tunnel" for a bit longer.

Does it make sense?

Thanks to all!

~ja

Question... I'm putting together a Demolition Man that was neglected for years, among the pieces I'm replacing, I need to to replace the eyeball, the current one is completely dry, any leads of who can have one on stock? the usual suspects don't have any.

Thanks for your input!

~ja

Awesome...! Thanks much for the info!

Hey guys!

Question, I'm shopping a DM with new plastics and I have a plastic which I cannot find where it belongs, any guidance will be greatly appreciated.

Thanks!

~ja

FullSizeRender (resized).jpg

Thanks...! nope, the one you are referring is a rectangular-shape that sits above the "car chase" tunnel, I have that one installed. Still, no idea where this one fits.

Thanks again!

~ja

Are you using the sabe board or a new one? I had the same issue with a new board, opto sensors were smaller than the originals. I had to put the board closer to the cams by using thin washers, problem fixed.

Hey guys! So something odd is happening with my DM (sigh) once in a while a ball will fall into the elevator, the claw will move to grab the ball, the magnet will pick up the ball from the elevator but I cannot move the claw using the triggers, the timer will time out, the magnet will drop back the ball into the elevator shaft and nothing. the machine will go into "ball search" but the claw nor the elevator will move. the DMD will be stuck on the "use the triggers to move the claw" with 0 seconds left. I have to turn off and on the machine for the elevator to push out the ball. During tests, the claw and elevator runs fine, left-right-up-down, no errors.

Any ideas?

Many thanks!

~ja

If optos... from the elevator?