I'm also in the club! Got it a few days ago. Lower left GI was out due to a burned fuse, and it did not have a coindoor lock, but those were easy to fix. I've been cleaning the hell out of it, I've never seen a more dirtier pin. I used bio ethenol, though I just read that this is not really advised on pinside. Still, have not seen negative effects, and it worked like a charm!
Before
2014-06-25 17.50.25.jpg
The Fortress Multiball insert is actually the worst one, it lifts up a little in the corner. I've already hammered it down enough with a wooden block and a rubber hammer. These inserts look crackled and are blackened on the inside, any tips on cleaning this?
I'm going for a full LED conversion, and I'd like to make some mods to it. I'd like to lite that crane/beam in the back at least, but are there more nice mods for this pin? I haven't seen many more.