I have newly found problems with my claw. Ive never gotten the claw out of range message. This is what I can figure out doing a switch test. Switch 74 Elevator hold works fine. What is switch 67 Elevator index? Cant find it. Also what are switches 25 and 26 Claw position 1 and 2? I see what I think are optos close to the motor similar to what works the flippers but am getting no response in a switch test. Am I missing the obvious?

How can I test the switches?? I need to test switch 67 as well if I can find it

Nobody can give advice on how to test these switches?

How do I run the elevator in switch test mode?

Got ya thanks

#67 works. Any way I can test that claw opto board??

problem resolved. Looks like the connection wasn't 100%.