Because of the flipper Column the right sling shot, pop bumpers and ramp switches are not registering in test either.
all of those Solenoids fire when in solenoid test
all wires look connected.
Everything is connected to the power driver board

What would be some possible problems that would prevent the switches from registering?

Thank you in advance

ok

Thanks Ill start tracing wires

Would one broken wire or incorrect matrix take out the whole column?

so the brown wire would be the common wire through them all
the left slingshot does not register, so that means the rest down the chain will not

would it be safe to say that the left slingshot switch is the problem since it does not allow contuinity to the rest of the chain?

j127 solenoid matrix (resized).jpg

ok i will

checked every lug
all wires are connected
no breaks in wires either

Spent a few hours diagnosing and researching last night
watched a few video's as I can fix a lot of the mechanical issues but not that great with boards and Multi meters.
I do know how to check continuity though

Im getting a ping from the 4th pin on j207
Im also getting a ping on the way down the column on the green yellow wire for every switch lug.

Does this mean its most likely the connector from the wires to the board?