Just wanted to share a few adjustment stories...
1. The opto plate, in back on the OOF drop targets on my Pro, was a lil high,
but I put up w it for almost a year until I had to tilt the machine this week...to get the ball to roll to the right so it's on top of the opto...
I figured out that its attached to the curved wall that wraps around the right side of LDP, so just tighten the nut underneath and voila!
(keep in mind you can over tighten and then it'll be WAY below flush)
2. The sw for lil deadpool didn't seem great, as I have whacked the F out of that thing and nothing.
The only way I found to adjust it was from the top, after removing the Lil Deadpool plastic,
seems better now.
3. I double checked the colossus jackpot standup, that adjustment seemed good.
4. Never been satisfied w the pop bumper activity,
I have adjusted the bottom one previously and that seemed to help a bit,
tried to adjust all of them, and now the top one is dead.
I think I'll adjust>turn on>put in into sw test>repeat as needed to get these right.
(I've written about this before, that mine came CLOSED, which seems opposite of how they should be set up)
which I think should be OPEN and Close to contact.
5. Finally installed the lil cliffy under the edge of that wall to the right of Lil Deadpool.
is that supposed to go "exposed glue side down" to adhere to the PF?
It's the only thing that seemed to make sense.
6. traded out 4 of the white lights at the top of the backboard, w red,
I kinda like it for now....
7. I did adjust the "shooter fork blades"
I very slowly from underneath pulled the mech down to duplicate the motion
as I thought, since the mech is cantilevered that it might cause a pull to one side,
and did discover that indeed one side hit the ball before the other...
adjusted w needle nose pliers from the top...