I had this documented in a notebook but it got lost in the Christmas preparation and festivities that have since overrun my basement. Now this is one of the last things holding me up from completing my re-assembly and playing.

Would any fellow owners provide me with precisely where each wire from the four pop bumper lamps need to be re-soldered to under the playfield? I have attached a picture of both above and below playfield for clarification. Thanks.

PopBumpersLampWiring_(resized).jpg

The picture of the underneath is not upside but the same orientation as the top of the playfield picture (not the Force coil outhole under the pop bumper labeled 4 and the semi-circle light board to the left of 3).

Does that change your numbering of the pop bumpers and their corresponding locationes (ie, 1 is 4 and 2 is 3)?

Thanks.

PopBumpersLampWiring2_(resized).jpg

I gotcha. The playfield is out of the cabinet so I can just spin it horizontally to get to the back. If it was in the cabinet still and I lifted the playfield then the image would be rotated 180 degrees. I'm tracking now. Thanks.

- Mike