I am working on a Jurassic Park where it must have been hit by lightning. I replaced every board except the sound board. The game now boots up. (I will fix them afterwards, I am lucky enough to keep spares to get games working faster.)
But the coils on the brown wire are not working. The brown wire goes to PPB J6 pin 3 (p.31). The board picture on p. 65 clearly shows the board has 6 fuses. But the schematic on page 65 shows J6 p 3 going through K1 to F7 to J6 p6. I do not have Fuse 7, 8 or 9 on this game or the replacement board I put in.
(Actually pin 1 and 2 are brown wires. There is no wire into pin 3, but schematic shows p1, 2, and 3 go to K1 then to fuse 7. It also shows J6 p4 and p5 go through F6 (which is good) and to K1 and out through F7 to J6 p6.)
I could buy a Rottendog that has the extra 3 fuses. Is there anything else to try to get these coils to work? The game I assume worked at some previous time.
I will also test the L/R relay since I realized that may be the issue.
Thanks
Michael