Was there battery damage on the board? If so that could explain your PIA issues.
(Topic ID: 270740)
You're currently viewing posts by Pinsider robotworkshop.
Click here to go back to viewing the entire thread.
Quoted from the96stang:Negative. Board is clean as a whistle. Im just an idiot who installed a PIA backwards and blew something up.
Ok. I ran into an issue where battery damage ate through a trace for the reset line going to the PIA chips. If there was battery damage or if someone removing a chip severed that trace then that could contribute.
Quoted from the96stang:Do you happen to remember what trace?
If I recall it ran under the crystal and to all the PIA chips. The PIA chips on that board didn’t work right without being reset. Sometimes prior work or people pulling out chips with a screwdriver will cut traces too.
You're currently viewing posts by Pinsider robotworkshop.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
