Working with someone on a Guns and Roses that worked perfectly fine until a rom was put in backwards when doing a rom change. The colored DMD is messed up looking but the game kicks into attract mode and starts a game. However, when closing the coin door, the coil under the apron holds. On the driver board there is a broken fuse holder that I will need to replace and then I’ll need to replace a 3 amp fuse that blew. If roms are incorrectly installed, what should we do? Thanks!

Where can I purchase new fuse holders? Thanks!

Gotcha. But there would be no damage to the boards because the ROMS were installed wrong right? Just the ROMS would be bad?

Thank you!

Is this correct?

EADA527A-D4E0-4330-A8AD-F1616EE6FAE0 (resized).png

Bump for clarification!

Thanks!

Is it possible that some drivers could have blown as a result of incorrect RAM installation?

I only say that because there is a holding coil (trough launch coil). I don’t have the schematics but I am hoping can tell me which driver so I can replace it