Nashville, TN
I Am having the same issue, except its just the DMD Issue. The game boots and plays fine, just no DMD. Any Ideas?
(Topic ID: 96724)
Linked Games
Jurassic Park
Data East, 1993
Topic Gallery
You're currently viewing posts by Pinsider newmanoconnor.
Click here to go back to viewing the entire thread.
Quoted from Cycloneman:did you check the voltages with a meter
I did, Everything is normal. I can't figure it out.
Quoted from Cycloneman:ok,do you have another ribbon cable you can try?
I've tried new ribbon cables, and new ROM and new Controller board. Same issue.
Swapped in Good DMD's, no bueno. It's DMD works in other machines.
I feel like there is something with the power supply or driver board. Fuse F7 on the supply(.5a SB) was blown.
Whenever I hookup the 7pin connector with the high voltage to the power supply,the far left pop bumper flashes continuously and it ejects two balls, everytime.
But its not the high voltage itself I don't think, because I have the same issue with a Color DMD.
Arrrrgh
Quoted from PinballManiac40:that is for the high voltage, which the ColorDMD does not use.
Are you doing this with power on? If so, that is not a good idea.
Post a picture of everything in the backbox and the back of the speaker panel.
I’m aware it doesn’t use the high voltage, and no I’m not doing anything with the power on.
Promoted items from Pinside Marketplace and Pinside Shops!
London, ON
You're currently viewing posts by Pinsider newmanoconnor.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
