Hey guys, Those are our buttons (Thanks Pingod), Wife (Brenda) sculpts and paints them all by hand. Just waiting for a few parts and they will be available. Games available at this point, or as soon as we get the parts, will be: AFM, MM, MB, NF, Flintstones, BSD, DM, CP. Not 100% sure yet, but I think $40.00, complete assemblies. They will be available in her ETSY shop Pinballshooters https://www.etsy.com/shop/PinballShooters , Lots of other stuff there... or send me a PM. Here are some Pics.

a dis bram red.jpg

a dis bram yellow.jpg

a dis demo.jpg

a dis flint.jpg

BU ON001C.jpg

BU ON002A.jpg

BU ON002D.jpg

BU ON002C.jpg

BU ON003.jpg

BU ON003C.jpg

a dis champ eye 1.jpg

a dis champ eye 2.jpg

a dis no fear.jpg

Yes, the sculpted part is basically the part of the button that says "Launch Ball", which I might add was broken on the 3 games I put them on here, MB, MM and AFM. So, not only do they look cool, but replace the often broken part of the button.

Sculpt is under a Clear lens, so the look great. Let me see if I have a pic where you can see the sculpt a little better.

Thanks, Dave

aBU ON001AA MARS.jpg

aBU ON001AB MARS.jpg

We do Tons of Shooter Rods too...

I think we are just waiting on Buttons, soon I hope!

Parts are all in and put together for these Buttons. Complete assemblies, $40.00 each. PM me here, or check them all out (as well as a lot of other stuff) at https://www.etsy.com/shop/PinballShooters

Popeye isn't up yet, or the second one for Champion Pub CP, I can send you pics if you like, but they will get up there soon.

Thanks, Dave and Brenda

Dalek is there for Doctor Who as well!! Popeye Pics coming soon.

Champion Pub is up, as well as Popeye!

a dis champ fisr.jpg

aBU POP1.jpg

Here is a couple of Pics of the Dalek for Doctor Who, oh and Bump! Other Pics are earlier in this thread.

Available here, or PM me.

https://www.etsy.com/shop/PinballShooters

Thanks, Dave

aBU DR1.jpg
aBU DR4.jpg
buon dr who.jpg

Yup, That's ours, there is a PinBot one too, in the same style. It was a tough one to figure out what to do because of the sides of her head.

https://www.etsy.com/listing/174792273/

I'll find the PinBot pic when I get home and post it.

Thanks, Dave and Brenda

aSH ON 114F BRIDE.jpg

No problem, here is the PinBot shooter rod.

aPIN SH ON 020A PINBOT.jpg