You're currently viewing posts by Pinsider isochronic_frost.
Click here to go back to viewing the entire thread.
Any suggestions on temperature? I had an old fish tank setup so I have a small pump circulating the water and a little heater currently set to about 150 degrees, figured it would speed up the process.
Any suggestions, might that be too hot?
As for buffing, I was just using steel wool, what’s a better option?
So what do you use for the wash? I stopped using the Evaporust because when I rinsed off the legs they’d immediately start rusting while rinsing.
I have used the paste but the legs seem to still rust. I’ve got the rustoleolum spray paint now so I’d like to derust, rinse so they don’t rust and then spray them the nice hammertone silver. Any suggestions or step-by-step process descriptions?
I have the PVC tube and to speed up the process I was using a small tank-heater to heat the evaporust to like 140 since I heard it does much better in hot water.
Also how many hours at that temp? I also was using a small pump to circulate the mix, I wasn’t sure if that’s good or bad.
You're currently viewing posts by Pinsider isochronic_frost.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/cult-of-evaporust?tu=isochronic_frost and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.