You're currently viewing posts by Pinsider Mojojedi.
Click here to go back to viewing the entire thread.
The creature is made of hard foam with a recess in the back. I cut a piece of half inch plywood to fit in the recess, then glued it in. Then I cut a piece 1/8 inch steel plate to 16 by 18 inches, and bent it halfway on the 18 inch side, to about a 60 degree angle. I also cut the two top corners so they would not show above the shoulders. Then just drill holes and screw it to the plywood and the top of the pin. I'll try to post a pic tomorrow.
You're currently viewing posts by Pinsider Mojojedi.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/creature-black-lagoon-topper-mounted?tu=Mojojedi and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.