1. Do I just re-cap all the boards or just test and replace were necessary?
2. I am worried as I don't know what mods have been done to the CPU board as there are a few mods and there is only 1 ROM in place rather than 5, picture attached so hopefully someone might give me some info on it.

After I have done and sorted those I will fire it up and check the transformers for the correct voltages and then attach the PSU board and check voltages again too make sure everything is ok.

I have removed the dodgy looking battery pack too

DSC00169 (resized).JPG

You're currently viewing posts by Pinsider jclocomotion.
Click here to go back to viewing the entire thread.

Reply

Wanna join the discussion? Please sign in to reply to this topic.

Hey there! Welcome to Pinside!

Donate to Pinside

Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!

This page was printed from https://pinside.com/pinball/forum/topic/cpu-board-and-eproms-etc?tu=jclocomotion and we tried optimising it for printing. Some page elements may have been deliberately hidden.

Scan the QR code on the left to jump to the URL this document was printed from.