Corvette
Bally, 1994You're currently viewing posts by Pinsider dvandentop.
Click here to go back to viewing the entire thread.
got a question on my corvette there is a little flapper on the motor that once the ball goes into the motor it will keep the ball from rolling back out. well sometimes it doesnt flip up to allow the ball to go to the ball lock mutiball holding area. is there any fix for this???
the only reason to get going again is to wait for the ball search to trigger all the coils and then the motor rocks and it will fall into place. i am guessing this could be somewhat a common problem????
Quoted from LTG:Never heard of it before. You'll need to get in there and figure why your little flapper isn't 100%.
Could be dirty, need adjusting, if it gets pulled by a spring on a wire arm on a coil be sure the spring hasn't slipped out of place. See if anything got bent or broken. Etc.
LTG
yeah problem is it doesnt happen all the time so sorta weird. yes it does get pulled by the coil. so will have to check it out.
You're currently viewing posts by Pinsider dvandentop.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/corvette-tech-help-ball-will-get-locked-in-motor-but-then?tu=dvandentop and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Etten-leur, NB
Kenosha, WI