I have converted two Corvettes to the drop targets. I'm working on a restoration of one now.

Here's the machine I'm working on now, I'm about 95% done.Corvette 079.JPG

Corvette 080.JPG

Here's a couple photo of the cabinet I just finished. I still need to install some new side rails. I also will be changing out the coin door.

Corvette 019.JPG
Corvette 020.JPG
Corvette 022.JPG
Corvette 023.JPG
Corvette 024.JPG

I have converted two games to drops. The Williams Radical drop is a great one to use. Just follow the link below and it tells you how to do the conversion.

Opto style 3-bank drop targets work fine! You do NOT have to use microswitch drop targets. The only stipulation to this is the opto drop targets MUST have a LM339 chip mounted on the drop target opto board (newer drop target banks, 1992 and later, have the LM339 remotely mounted, and can not be used

http://www.planetarypinball.com/mm5/Williams/archives/corvette.htm

Rob

I have made up some Route 66 mirrored acrylic to put on the Corvette speaker panel. I think they look cool. They are held on by magnetic tape. If there is any interest in getting a set, I have just listed some on E-Bay. $28.00 Shipped anywhere in the lower 48.

Rob

DSCN4512_(resized).JPG

DSCN4513_(resized).JPG

pinmaniac

When I restored my Corvette I couldn't find any black side rails, so I just bought a set of stainless one from Pinball life and had them power coated, Looks great.