EDIT: disclaimer - apparently the way I hooked it up isn't the correct way? But wiring the correct way didn't work for me. So install at your own risk I suppose.
Got mine installed. Here’s some helpful install tips for people who are dumb at this like me
1. Pic i have above is where you plug power into. Should look like this:
EBFE185E-1B27-415B-A1ED-F61C3F9A1FEE (resized).jpeg
2. Mounting. Don’t forget about the clear plastic color dmd guard which is at the bottom of the box under the foam. After removing the old dmd, there will be 6 screws lodged in the metal panel (unremovable). Put the clear plastic on, then use the 2 washers (color dmd) + 1 black spacer (existing) + 1 extender (color dmd) on each of the corner screws. Install washer > spacer > washer > extender (at least I think that’s the order):
673DC2A1-2BC9-4426-A29B-CE9D5AA8E68C (resized).jpeg
3. Install the color dmd and use the color dmd hex extenders (4) to lock dmd in place. Use the 2 mounting screws on the dmd for the existing zip tie wire runs.
8CDC30A7-B2ED-47AB-BA55-95A28E0F1361 (resized).jpeg
When all is hooked up. Color dmd should look like this:
3F962C5D-4A54-4D10-92FA-3EF9B4939050 (resized).jpeg
And power supply from spike board should look like this (keep in mind the tabs on the cable connector need to be bent in order to firmly be seated) - and make sure your ground black wire is top:
EBFE185E-1B27-415B-A1ED-F61C3F9A1FEE (resized).jpeg
Step 5: wait for winter. Speed up the process with eggnog + rum