Chicago Burbs, IL
Elongate the hole on the bracket. You'll get up to 1/8" Common fix.
faz
(Topic ID: 264271)
You're currently viewing posts by Pinsider pinball_faz.
Click here to go back to viewing the entire thread.
Finally! I found this post. I snipped this photo for future.
A good photo of the operation here:
faz
Quoted from gutz:I would first see how much play you have in the factory holes. Loosen the four screws holding the mpf, push and hold the mpf back as far as possible while tightening the screws. If that doesn't buy the clearance, then I would modify the bracket.
That is VERY sound advice. It's easier to take metal away than to add it back 
faz
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider pinball_faz.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
