(Topic ID: 82515)

Clear coating. What about screw holes?

By Cali9dub

7 years ago


Topic Heartbeat

Topic Stats

  • 11 posts
  • 7 Pinsiders participating
  • Latest reply 7 years ago by Cali9dub
  • Topic is favorited by 2 Pinsiders

You

Linked Games

No games have been linked to this topic.

    You're currently viewing posts by Pinsider Freeplay40.
    Click here to go back to viewing the entire thread.

    #7 7 years ago

    I always drill them. Doing a High Speed playfield swap right now and I pre-drill all the holes that screw directly into the playfield...the holes that come from Classic are still too small (better too small than too big) for the screws which results in "mounding". Always want the proper size hole for a screw... If in doubt try in a scrap piece of wood first.

    #8 7 years ago

    Followup... As info I pre drill playfield holes where the screw goes into the wood with a 3/32" bit. Believe that's the same one I use for the wire lane guides as well.

    You're currently viewing posts by Pinsider Freeplay40.
    Click here to go back to viewing the entire thread.

    Hey there! Got a moment?

    Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside