Hello everyone.
Got an issue I am trying to address. My Chicago coin kicker is eating up the rubbers on the kickback area near the flippers (where it hits the ball back). I have gone threw 2 rubbers in about 2 months . Can I just order the rubber for that specific part from someone or do I have to order the whole kit again? Any help would be appreciated it. I am not sure of the size for that rubber.
Quoted from Schamattack:Can I just order the rubber for that specific part
Quoted from Schamattack:My Chicago coin kicker is eating up the rubbers
You also want to try to figure out what is going on that that is happening. Shouldn't be happening at that rate. Confirm correct coil and kicking action, etc.
Quoted from currieddog:You also want to try to figure out what is going on that that is happening. Shouldn't be happening at that rate. Confirm correct coil and kicking action, etc.
And correct rubber size. The kits are not always correct.
Quoted from currieddog:You also want to try to figure out what is going on that that is happening. Shouldn't be happening at that rate. Confirm correct coil and kicking action, etc.
The source of the supplier is also a big factor. I once purchased a set years ago from those "Guys" in Michigan, the rubbers did not last 3 months. I have had great long lasting success with rubbers from PBR & Marco.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/chicago-coin-kicker-eating-up-rubber and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Milwaukee, WI