hey guys! Just picked up my first pin , checkpoint! It has a new rotten dog power supply board and a new dmd display. I’m learning the ins and outs on this one and while it is in working condition , it has little issues.
Issue 1# the lights under the “turbo” art and “boost” Art beside the flippers don’t work. They’re chained with a bunch of other lights and also don’t work. Multimeter shows zero volts dc. Where should I be looking?
Issue 2# the speaker inside The pin had one wire taken off, so I soldered it back on but it still doesn’t work. Then I found out the left speaker in the back head also had one wire disconnected so I soldered it back on and it works now but it’s quiet. I went to the sound board and found the connector that has all the wires and where it’s labeled sp3 (speaker in the pin) the heat sink , first one from the top can give you third degree burns. It’s producing extreme amounts of heat. Why??
Issue #3. This sucker hums pretty good and loud on the attract mode. Tried tightening the screws in all boards but it was a no go.
After taking the picture of the pin, I noticed my coin return lights are no longer working either lol
987BC6DC-9FD6-44A5-801B-5B468384EA7E (resized).jpegimage (resized).jpg