Does anyone have experience with this error?

Steps so far....

1) Replaced both fuses even though they looked fine
2) Confirmed I have six solid LED's and one flickering (LED3)
3) Reseated all of the molex connectors on the Opto Board

Here is a YouTube of the Powerboard...

Ideas?

Thanks in advance as always...

Dave

pasted_image (resized).png

Yes! Two of them in matter of fact. Does that create an issue?

I have the LED power for the Lighted Backpanel and the power for the new ColorDMD I put in.

Well that was it. I was able to piggyback on the ColorDMD. But when adding the Lighted Backpanel as well, no dice.

Is this where I should probably get one of those dedicated small powerboards for mods? I have seen them on Pinside before.

Now I can start doing my testing.....have to figure out why the new 3rd magnet opto isn't working. Why do we do this to ourselves again???

Thanks!

Dave