Note that the two 5" rings in the back center go around behind the diverter...not in front of it.
You're currently viewing posts by Pinsider freeplay40.
Click here to go back to viewing the entire thread.
Quoted from matt1999:I was surprised that the connection to the ramp switches would not fit through the playfield to disconnect the entire ramp.
If only they had switched the plugs, the male will fit through the playfield...Female will not. I reversed the plugs on mine so I could get it in and out easier. The only other way to get the ramp out without removing the back board is to dismantle the switch stacks.
Quoted from zosofan:Freeplay40 I am finally installing your ramp and changing out the rubbers. I am looking at swapping the housings on the pigtail, but it does not look like i have the correct molex pin extractor. What size extractor is used or do you have a link to one?
eye thank ewe
zosofan
The Pin size is .062. Here is a link to an extractor at Digi-Key
https://www.digikey.com/en/products/detail/molex/0011030002/228689
or here is one on Ebay...
You're currently viewing posts by Pinsider freeplay40.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/changing-rear-high-speed-5-rubbers?tu=freeplay40 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.