I just bought a Creature that had a playfield swap. I have a question about a hex spacer and a question about the ramps.
In the back left upper ramp, between where the metal ramp u-turns into the plastic creature ramp, there should be a tall hex spacer that holds up that part of the ramps complex by attaching to a plastic tab on the plastic ramp. At least I assume there is one. On my game, there is a short hex spacer that doesn't reach all the way up, therefore my ramp is not quite fully elevated. Can someone tell me if their game has one hex spacer or a two piece hex spacer in that position attached to the plastic ramp? Does anyone know the correct length needed or part number?
Also, the front of the creature loop ramp is a little high and I have to push it down slightly to slide on the playfield glass. I believe it then rests on the glass. Is this normal or should it be adjusted somehow? Perhaps the correct back end elevation will help?
Thanks.
Dave