Quoted from GorillaBiscuits:gunstarhero Update... I installed it no problem, but the cup is sitting up slightly too high and of course the optos are picking it up. It fires over and over since it thinks it's a ball.
Would the best course of action be to simply cut off a bit of the black end that the cup screws into? Not sure how far down the threads go. Adding washers under the entire mech wouldn't work as the optos would move down with the entire thing as well.
Cheers.
You can either:
Remove the rubber stopper on the bottom of the metal bracket if there is a LOT of room you need to move the plunger down, or
Slightly, SLIGHTLY bend the bottom metal bracket down some to get it to sit lower.