Quoted from bsbdmd83:Well I spoke too soon. Found exact replacement sockets and replaced my missing one. Ran ramp light test and only 6 bowl lights work. The two that are out are on same on trace. Continuity shows good wiring between sockets and the connect with the header pins. Dmm shows much higher voltage on this pin on wire connector.
Also noticed similar issue on main chase ramp. Smaller length board at end of ramp has 2 sockets out which are connected to each other.
Could this be a problem with the chase board? What should be testing
Thanks everyone
Hi - apologies for the thread resurrection but do you remember where you got those replacement sockets from? Struggling to find some.