Centaur II
Bally, 1983You're currently viewing posts by Pinsider DnDPins.
Click here to go back to viewing the entire thread.
Once out of about every 20 - 25 times the bank of targets go down, they fail to reset. It is usually reset on the next ball. FYI...The previous owner replaced the targets and springs. What can I do to eliminate this?
Thanks,
Dave
The switches are all set properly.
Now the drop target reset does not even take place in the solenoid test mode (happened only once) or upon next ball.
The resistance on each coil is good (21.5). Any ideas on where to go next?
Thanks,
Dave
Quoted from Barakawins1:I think Shockme is correct. You have to clean the leaf switch contacts. I use 2000 grit sandpaper for this and it works well. Place
between both contacts for each target when the targets are down and swipe a few times. Should clear it up.
Thanks for this input however doesn't it seem that the fact that it does not reset in test mode or upon next ball indicate something other than the switches? It seems logical to me that if it were switch related, it would not reset during the ball but would in test or next ball.
You're currently viewing posts by Pinsider DnDPins.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/centaur-ii-drops-target-sometimes-do-no-reset?tu=DnDPins and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
