(Topic ID: 80551)
You're currently viewing posts by Pinsider Sc1f1.
Click here to go back to viewing the entire thread.
Acworth, GA
Quoted from PinballMikeD:Use a dremel and grind down the flared section of each post (only remove the curl – so the posts will still fit into the plastics). Position your posts on the playfield. Then rest your new plastic on top of the posts and the mounting screws will hold everything is place on the playfield. I’d use a washer between the screw head and the plastic. Hope this helps.
Perfect! Something like that was my next thought. I was going to make the hole bigger to accommodate it all but then use the washer. I'll dremel it off. Thanks Mike
Promoted items from Pinside Marketplace and Pinside Shops!
Zemst
You're currently viewing posts by Pinsider Sc1f1.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
