On my Capcom Airborne, it bothered me that one flipper was aligned slightly lower than the other. I finally got around to adjusting them so they aligned properly, when I noticed that one flipper fully up was now higher than the other. After some more investigation, I noticed that there are two different flipper linkages, one with a tapered end, one with a rounded end. The tapered ended one slides further into the coil sleeve, and allows the one flipper to travel further up than the other.
My question is if there is any way to fix this and/or get replacement parts, or is the only option to swap over to full Williams assemblies? Any input is appreciated.
IMG_1746 (resized).JPGIMG_1747 (resized).JPGIMG_1750 (resized).JPGIMG_1753 (resized).JPGIMG_1754 (resized).JPG