I fixed mine with JB weld, but only had the two end welds break loose, not the entire bar like yours.
You're currently viewing posts by Pinsider pin_guy.
Click here to go back to viewing the entire thread.
I fixed mine with JB weld, but only had the two end welds break loose, not the entire bar like yours.
Quoted from mg81:Most epoxies have strength in at least the 100's of PSI. Start to add up the square inches on that lockdown bar. That glue joint if well done would need 1000's of pounds of force to break it apart.
Very true, and worst case scenario, if it doesn't hold you can just sand/grind off the epoxy and your back in the same place you are now.
You're currently viewing posts by Pinsider pin_guy.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/can-this-be-fixed-1?tu=pin_guy and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.